This decorative garland is simple to make, will look great around your front door and be the perfect accent to a spring wreath!
To determine how long your garland will need to be, measure both sides & across the top of your doorway. Add your measurements together for your garland’s finished length.
Then, gather the following ingredients: spool of 8 lb. fishing line, spring silk flowers (3 different colors were used in the garland at left) and a low melt glue gun.
DIRECTIONS: Measure a piece of fishing line (slightly) longer than your doorway’s measurement (2 sides+ the top + apx. 4”). The 4” of extra length will allow for slight shrinkage that may result from using hot glue with fishing line. Lie your length of fishing line out on a (protected) tabletop. Beginning at one end, glue your first flower to the fishing line. Then, approximately 6” from there, glue your next flower to the line and so on. Make sure you use a small line of glue (vs. a dot) along the center back of each flower to balance the weight of your blossom along the length of the fishing line. [Assembly hint: I found it was easier to put glue on the back of the flower blossom, lie it face down on the tabletop, attach the fishing line to its back and hold the line down & in place until the glue starts to cool. Hammer small, picture hanging hardware into each top corner of doorway to hang your garland on. This a simple, light-hearted & Springy way to greet your guests at Easter!
No comments:
Post a Comment